Very unique injector problem (update 2-26 w/vids)

Small talk, Forum and site news...

Moderators: DJpowerHaus, mattmartindrift

Post Reply
Old Colt
Addict
Posts: 129
Joined: Thu Nov 30, 2006 7:48 am
Location: Vermont USA
Contact:

Post by Old Colt »

That kind of sounds like the O2 is not reporting correctly.

Run it till it warms up and can't take boost, then unplug the O2 sensor and drive it without the O2, see what that does.
Old Colt
Addict
Posts: 129
Joined: Thu Nov 30, 2006 7:48 am
Location: Vermont USA
Contact:

Post by Old Colt »

Has the ECU been reflashed? And do you have and 87 ECU to try in the car?
Old Colt
Addict
Posts: 129
Joined: Thu Nov 30, 2006 7:48 am
Location: Vermont USA
Contact:

Post by Old Colt »

It might be worth a check.
Old Colt
Addict
Posts: 129
Joined: Thu Nov 30, 2006 7:48 am
Location: Vermont USA
Contact:

Post by Old Colt »

In my own 87 Starion when the O2 failed it went lean, Way lean. I had to unplug it to drive home.

There are cars that do not like a fuel meter sharing the O2 sensor, I have run an old Hallmeter on three of my Starions so I would not jump there yet.
Some meters will mess with the impedance in the circuit.
peregrine
Too Much Time on His Hands
Posts: 492
Joined: Tue Dec 28, 2004 5:26 pm

Post by peregrine »

mainstream wrote:GM Maf and Maf translator! :wink:

This isn't like a vacuum leak where it stumbles and runs like crap. The ECU quits delivering fuel period.

Kane
theres your problem right there. dump that piece of shit and go stand alone if you have to. i tried for MONTHS to get that motherfucking asshole cocklicking piece of dog shit to work to no avail (can you tell i dont like that thing?) :lol: :lol: :lol: anyway can you get a 2G maf to work? thats what i use now and it runs and idles so smooth its not even funny.
Image
Old Colt
Addict
Posts: 129
Joined: Thu Nov 30, 2006 7:48 am
Location: Vermont USA
Contact:

Post by Old Colt »

I also do not like the GM crap, for one there is no barometric sensor, at least in the one I could net get working well.
The Starions are a fuel only injection system, put a Megasquirt on it. Get it running well and then convert the ignition over. And be careful with RC injectors, How can he give you balanced injectors, they are two different sizes.
Also the Starion injectors are a 60 Degree spray pattern, any change to them narrows the spray, this is not an issue over 6000rpm but is a big loss of power below that.
Now that I have ranted, did you get a chance check things yet?
Old Colt
Addict
Posts: 129
Joined: Thu Nov 30, 2006 7:48 am
Location: Vermont USA
Contact:

Post by Old Colt »

And how about the O2 signal?
Old Colt
Addict
Posts: 129
Joined: Thu Nov 30, 2006 7:48 am
Location: Vermont USA
Contact:

Post by Old Colt »

No Cherokee Trails rally this year, I won't be down your way this spring.
Old Colt
Addict
Posts: 129
Joined: Thu Nov 30, 2006 7:48 am
Location: Vermont USA
Contact:

Post by Old Colt »

With the job, kids, and wife I get to work on it about 30 minutes at a time
Oh I got that point years ago and one had to go!
It was the thirty miniutes for my own. And I don't even have kids.
Bill Hincher
Donating Member
Posts: 1625
Joined: Thu Jun 22, 2006 8:57 pm
Location: Toledo,Ohio
Contact:

Post by Bill Hincher »


its gotta be the injectors or the ECU, its running good when its cold because its rich, when it goes to closed loop, it wont run over ' 2500 rpm? ' I am guessing, thats when the ecu gets information from the air flow input meter ( whichever one you are using) before 2500 most ECU's are in preprogramed mode

PM me and I will give you an adress for a mechanic,s net work I belong to and I will fix you up with the most up to date info
Bill Hincher
Donating Member
Posts: 1625
Joined: Thu Jun 22, 2006 8:57 pm
Location: Toledo,Ohio
Contact:

Post by Bill Hincher »



An Ignition coil will act that way
Bill Hincher
Donating Member
Posts: 1625
Joined: Thu Jun 22, 2006 8:57 pm
Location: Toledo,Ohio
Contact:

Post by Bill Hincher »

hey kane,
whats going on with your engine? did you get it running right?
Bill Hincher
Donating Member
Posts: 1625
Joined: Thu Jun 22, 2006 8:57 pm
Location: Toledo,Ohio
Contact:

Post by Bill Hincher »

check this guy out Kane, seems to have the 'hands on' guy in mind

http://www.diyautotune.com/tech_article ... _laser.htm
Post Reply