Evo 5 parts

blooz · Post by **blooz** » Sat Mar 11, 2006 7:13 pm

I've got the possibility to buy an Evo 5 turbo, exhaust and intake manifolds, will the manifolds will fit my 1G DSM engine?
Any experiences with this manifolds? since the intake is right on the side we need for a RWD 4G63.

If the manifolds doesn't fit i'll get just the turbo, any comments?

Cheers.

blue1 · Post by **blue1** » Sun Mar 12, 2006 6:49 am

Split pulse housing forget it if you dont get the rest

blooz · Post by **blooz** » Sun Mar 12, 2006 10:23 am

You mean i'll have problems because it's twin scroll? I'm planning to build another turbo manifold since i've got a 2G DSM ported but i think i'll have clearance issues, i need to put the turbo up...
Any suggestions for a new exhaust manifold?
I think i'll use that turbo anyway... it's a gift.

Post by **DJpowerHaus** » Sun Mar 12, 2006 7:51 pm

The Evo 4+ manifold and turbo has been used on DSM motors in the past. The most vivid memory I have was Dentsport Garage's. They had to use 2x 1/2" flanges to space the compressor housing far enough to clear the balance shaft buldge in the block. I think they had to move the Alternator and power steering pump too.

I have no clue about the intake manifold though.

My opinion: You'll spend more money making the stuff that was given to you work, than you would just buying a new new turbo that would bolt on.

Mike · Post by **Mike** » Thu Mar 16, 2006 7:29 pm

I don't believe any of the manifolds will fit. They are basically the same as the current EVO engine, with the timing belt on the passenger side.

Mike · Post by **Mike** » Thu Mar 16, 2006 7:31 pm

I don't believe any of the manifolds will fit. They are basically the same as the current EVO engine, with the timing belt on the passenger side.