g63b/4g63t

motorsport_5 · Post by **motorsport_5** » Wed Sep 26, 2007 9:07 pm

Hey people, i am from new zealand so most of the cars i talk abot are named different to yours. Anyway i have a 1982 Mitsubishi Sigma rwd 4g63 sohc carbouretted. i got myself a g63b engine for it out of a Mitsubishi Pajero, along with the computer, loom etc, i am looking to bolt this engine upto my 5 speed sigma gearbox and complete the wiring loom so i have a turbo sigma. Does anyone know of any troubles i may have like the box not bolting up etc.....

Thanks

S0LJAH · Post by **S0LJAH** » Fri Sep 28, 2007 4:20 am

hey mate im form nz too so can help you out a bit

where bouts u im in chch

youl have to suss out what style the pajero motor is i have no idea what they use etc

easiest motor etc is the starion one that way you could just use everything starion

ecu gbox etc

motorsport_5 · Post by **motorsport_5** » Wed Jan 09, 2008 3:07 am

Hey to shed some light on my questions that i asked, The Pajero motor that i have sourced is a g63b-the exact same setup as the starion, everything is the same except for the gearbox, now my sigmas na block was narrow and the g63b block is wide, so i have sourced a starion gearbox, this creates the problem of clutch. my sigma was cable clutch and the starions box is hydraulic so i have also got the pedal box and plumbing from that pajero to fit to my sigma, just got to put a hole in the firewall etc.
Austarion are not much help.