ANYONE HAVE STOCK ECU?

mitsuman · Post by **mitsuman** » Sun Nov 05, 2006 7:39 pm

does anyone have a stock ecu for sale? i think mine took a dump. it runs but cuts out. i'll even give it to who ever has a good one. if they want it.

thanks
greg.

jeffball610 · Post by **jeffball610** » Tue Nov 07, 2006 6:54 pm

I second the bad capacitor. Have you pulled it out to look at the board at all? There will likely be leaks from a couple capacitors if it's bad. Check Keydriver and TMO for directions and modifications. You can also check eBay for an ECU. They're on there all the time.

Post by **DJpowerHaus** » Thu Nov 09, 2006 5:47 pm

mitsuman wrote:Posted: 08 Nov 2006 09:54 pm

not the caps. just had them done. it is a 1st gen. and i went back over all my wiring found nothing. the problem im having is that it just falls on its face when i give it gas. fuel pressure is good. i have no air leaks any where. the only thing i see is that i have good spark on cyl 1&3 and 2 & 4 have weak spark. its not the coil. i tried a spair. and wires are new. also swapped them. still has weak spark. also i cant get the fuel side of the main relay to work. but when i plug a differnt ecu in that is a no start . the fuel side works. i have a ? about the caps though. the guy that did it only replaced 2 of them. i see three. there are the 2 big ones and then the 1 little one. the little one he did not replace, because it did not look to be leaking. does anyone know what the little cap works? also i dont know if it matters or not but this computer was a no start when i got it and i had it capped and this is how its been running since.