Engine Bay Measurements

All the oily, spinning bits

Moderators: DJpowerHaus, mattmartindrift

Post Reply
AustinTSI
Addict
Posts: 108
Joined: Sun Nov 21, 2010 5:10 am
Location: Austin, Texas

Engine Bay Measurements

Post by AustinTSI »

So I found this picture here on Project Zero G but I can't seem to find the measurements that go with it. I think this is something a lot of people would like to have (and I need them also).

The only modification should be G which measure pillar to the master cylinder.

So how about we add G2 which will be pillar to pillar.

Image

What I have found so far is:
* intake manifold surface of DOHC 4g64 head to the pillar is 12"
* DOHC 4g64 head width is 7.5" intake to exhaust manifold surface
* center line of DOHC 4g64 head to outside edge of 1G intake manifold is 14.5"
Top
DJpowerHaus
Sir Post A Lot
Posts: 1779
Joined: Wed Apr 07, 2004 3:24 pm
Location: Baltimore, MD
Contact:
Contact DJpowerHaus

Post by DJpowerHaus »

I remember it was on the old site which is still available in the archives (See the FAQ)

http://projectzerog.com/archives/ZeroGv ... ments.html

I'm doing another swap this fall so I'll try to document everything better this time around and update the site... maybe even a few how tos.
Image
Getting the engine bolted in is about 10% of the way there.
The next 80% can go quickly with help and skill.
That last 10% takes about as long as the 90% that came before it.
Top
Bill Hincher
Donating Member
Posts: 1625
Joined: Thu Jun 22, 2006 8:57 pm
Location: Toledo,Ohio
Contact:
Contact Bill Hincher

Post by Bill Hincher »

DJ make sure and let me help you with your swap
Top
Post Reply

Return to “Swap Mechanical”