My RWD 4G63 Parts W58 & D50 trannies, longblock, harness

1941galant · Post by **1941galant** » Wed Jun 09, 2010 12:43 pm

Here's a link to my thread on GVR4.org so you can see pictures

http://www.galantvr4.org/ubbthreads/sho ... Post905959

~Semi-complete 6 bolt longblock - $2000
*Details - New OEM shortblock ( Crankwalk was selling it ),rebuilt head w/ 3 angle valve job, MLS mitsu head gasket, ARP studs, SS springs, Evo 9 springs and retainers (about 5 k miles), 3g lifters, MLS exhaust mani gasket, new valve stem seals, new oem rear main seal and case, and a powder coated valve cover. I accidentally threw out some valve keepers when I was installing the springs and retainers, I will order more when I call JNZ next.

~RWD 4G63 clutch setup - $255
*6 bolt Fidanza FWD flywheel modified for pilot bearing and a southbend DXD pressure plate and clutch disk *will separate*

~RWD 4G63 flywheel - $25
*Stock flywheel modified for pilot bearing

~W58 Toyota Trans w/ 70k miles - $199
*No bellhousing or shifter, I have not personally used this

~Dodge D50 narrow block trans - $160
*Mileage unknown, seems to be in decent shape (does not include waffle trans pan)

~91-94 DSM engine harness stripped for use in RWD project - $80

~6 bolt front case (straight cut gears) - $85
*Decent shape, balance shafts are blocked off, comes with gasket and seals

~90 throttle body - $30
*Complete except for throttle stock switch

~91-94 complete throttle body - $35
*Complete except for throttle stock switch

~90 CAS - $25

~1g uncrushed BOV w/ dejon leak stop hobbs switch - $50 SOLD

~6 bolt front case (helical cut gears) - $35
*It seems to be in decent shape with some minor wear in the oil pump. I wouldn't hesitate to use this in an older engine.

~Oil catch can - $25

I also have a spearco water/air I/C that I was going to use, I'm asking $175 +s/h for that.

1941galant · Post by **1941galant** » Wed Jun 09, 2010 10:45 pm

My bad, I live in NE Pennsylvania (Danville, PA 17821). I'm willing to ship just about anything, and meet people if they pay for gas and what not.

kensington164 · Post by **kensington164** » Mon Jun 14, 2010 6:46 pm

I was wondering you might have to 2 motor mounts needed for the block. I would be intrested in that stock flywheel and motor mounts. Let me know. If anyone see this and has the 2 correct right side motor mounts let me know thru PM not trying to jack the post.

1941galant · Post by **1941galant** » Tue Jun 15, 2010 3:22 pm

I actually forgot about the motor mounts, I do have two 4g63 D50 motor mounts (that attach to the block) sitting here. I'll send you a PM.

Hill

1941galant · Post by **1941galant** » Fri Jun 18, 2010 9:31 am

Bump for some new prices.

77amc · Post by **77amc** » Mon Jun 21, 2010 12:16 pm

What are the dims for the water intercooler?

E