cts and dash temp sender question

mr.andaya · Post by **mr.andaya** » Mon Oct 26, 2009 1:02 pm

Hi guys, i had a quick question regarding the cts and dash temp senders..... i am going to run the front exit w\o the thrmostat housing and run a inline housing on the bottom radiator hose. i wanted to know where you guys would run the sensors? i would like to run them on the plug behind the head but im not sure if thats the best spot. what would you guys suggest?
Ill post pics of my mock up setup if you guys would like.
-joe

Bill Hincher · Post by **Bill Hincher** » Mon Oct 26, 2009 9:04 pm

as close as you can to the rear exhaust valve in the head, that should be the hottest place

mr.andaya · Post by **mr.andaya** » Mon Oct 26, 2009 11:18 pm

ok thanks bill =)

-joe

mr.andaya · Post by **mr.andaya** » Tue Oct 27, 2009 8:51 pm

one more question, i didnt want to make a new thread.

what is the 4 wire connector by the water neck? o2 sensors and reverse lights etc? its with the cts and temp guage.

thanks again
-joe

shroder15 · Post by **shroder15** » Wed Oct 28, 2009 1:18 am

Should be the O2 wire...does it have a round plug on the end?

mr.andaya · Post by **mr.andaya** » Wed Oct 28, 2009 9:23 pm

yup round plug 4 wires.