Back with some more problems !!!!!!

[Turbotech7]

Hey everyone, my pos finally got worked on after about 2 months of running around, i finally got time in the garage to start on the car again! This time everything seems to be a lot easier, so much for getting the Dec. 31st deadline. Anyway i put the clutch together , well the brake fluid, 1st pump BAM it steekts brake fluid inside the car. Now with that replaced i tried bleeding it and its self bleeding the slve cyl i got with the supra trans at the junkyard leaks more than it moves!Now for the question what SIDE feed slave cyl would i need to make it work? the master cyl is the 5/8 " piston diamiter one from toyota.

I actually relied on the slave cyl so much that i built the project around it , it sits 1/8" away from the steering rack U joint, so if i get a shorter stubby ne that will bolt up i could remake the motor mounts and have the motor go on straight. Right now its not bad but it is coked 1.2 degrees but i dont think its that big of a deal, after all i didnt have much into it so far. im still on a budget as of the other day all the recipts total $998.13 with everything even with 4 piston RX7 calipers !

Well ialready took much of your time, any help would be greatly appreciated.

http://community.webshots.com/user/Turbotech7

New corolla pics updated