driveline ?

[hankhawk]

What driveshaft would you use if u used w58 transmission set up/ and would u have to make a custom crossmember for the tranny

[Bill Hincher]

the last time I looked for a slip yoke it was for the R 154 trans, start out looking for a common standard U-joint size, like a 1350 ( being the largest ) or a 1310 ( being the smallest), it will make the driveshaft ' servicable' instead of the Toyota unit that requires the whole drive shaft
I found the parts here the last time
http://www.driveshaft.com/catalogs_seri ... ies=Toyota

I will count the splines and measure the output shaft and look around to find it, but I know they are available, here is the thread we used last time we talked about it
http://projectzerog.com/forum/viewtopic.php?t=600