FS: 4g64, wiseco pistons, hbeam rods, hks cams, rx7 trans

[1 Bad 68]

Got a wideblock 4G64, Wiseco forged pistons, Eagle H-beam rods and HKS 272/272 cams for sale. Also have 2 heads, one is stock, one is midly ported and 1mm oversized valves. Not sure if I want to sell the heads or not at this point. RX7 turbo II trans w/ b2600 bellhousing if you want to go that route. Also made adaptor plates that have been tested to drop the 4g64 in the starquest and mounted the trans and test fitted. The plates move the engine forward 2" and the trans bolts directly in as there is another set of tapped holes 2" up in the frame! Its pretty sweet! All you have to do at that point is have a drive shaft shop extend your driveshaft exactly 2". Car is back home away from the lift so I can't show you pics of the trans bolted up, didn't have my camera that day. Heres a few pics:











Prices are going to be:

4g64 short block $300+shipping
Wiseco pistons-custom to use w/ 4g63 rods (pin height modded) $425+shipping
HKS 272/272 used $485+shipping
Eagle H-Beam rods $350+ shipping
Adaptor plages w/ motor mount brackets $135
RX7 turbo II trans w/ bolt up bellhousing $300+ shipping.

[DJpowerHaus]

Would you consider selling me just that bellhousing?

[DJpowerHaus]

oh yeah.. WTF are you selling all this stuff for? You're going to be pissed when I get some dyno numbers that will blow your socks off your body in a few weeks. Your set is as good as mine I bet.

[1 Bad 68]

I drove my old DSM and it broke all 4 loose in 2nd from a roll (in the rain), needless to say its not for sale anymore, changed my mind again. However, I did get all timing components, oil pan and front cover donated to me from a friend to keep going with the swap. Damn him! Someone already has called the trans w/ the bellhousing, if that falls thru you can get the bellhousing.

[markviiisvt4]

where are you located at?
might consider taking almost all of it