FS: T-56 4g63 bell housing for FWD narrow-block motor

[AustinTSI]

I picked this bell housing up to match up to a 2.4L G4CS block but I just can't seem to find one anywhere near me. I was planning on putting it in my Starion (RWD) but it will bolt up to any FWD 4g63 or FWD 4g64 in a RWD configuration.

This is for an LT1 T56. Because I don't need it any more, this deal ALSO INCLUDES an ACT Streetlite 6-bolt flywheel already bored out for the t56 input shaft and the throughout bearing as shown in the first pic.

This is from Bills Auto Fabrication and you can see it here: http://www.billsautofab.com/recent_mit.asp and here http://www.projectzerog.com/forum/viewt ... hlight=t56 but he hasn't had any available for years.

I'll take $650 shipped anywhere CONUS.






David
david dot satchell at austincs dot net