Intake Manifold brake line clearning

[Xharlequinx]

So I have an aluminum intake manifold for my 4g64/3t set up that I've had put into the 86 starion I have.
Everything is almost done, except ran into problem with the brake line grazing the left corner of the manifold..
I was wondering if I just fabricate with what I have, (cut the manifold and have someone weld a bent piece to allow the brake cable to not touch) or sell it and buy another manifold?
Does anyone have experiences like this, and what would you suggest?

[Xharlequinx]

I think I'm just going to switch the 1g manifold from my eclipse and tap the left side, make it a rwd manifold, do the opposite for the aluminum manifold on the 64/63t set up in the starion.
Should be the easiest fix.