MAS HOOK UP

[L300 downunder]

ok i believe i have ecu wiring sorted b38---what ever etc!

but can anyone tell me where am i meant to wire MAS wires 2?

RUN DOWN- i am removing a sohc carb 4g63 (s@#ta) engine 2 a dohc injected engine 4g63 into a 1989 L300 van and sparky work is not my best subject!

[jeffball610]

Check out VFAQ.com. There is a writeup on putting a 2G MAS into a 1G car. Not exactly what you're doing, but it will explain some things. Also, there should be an ECU pin out diagram that will show all the functions of the ECU wires.

[L300 downunder]

so can someone put me right!
i have notice every wire heading out of the smallist ECU plug needs to be hook up either to battery, ground or ignition?
is correct or am i grasping a sraws here becuase if this is the case its not that hard is it!
one problem i am having is what to get rid of on a auto trans when i have a 5 speed manuel i read some where that ya groung the neutral safety switch but where at the auto plug end or anywhere??