SOHC->DOHC - Proof Read... suggestions.

All the oily, spinning bits

Moderators: DJpowerHaus, mattmartindrift

Post Reply
DJpowerHaus
Sir Post A Lot
Posts: 1779
Joined: Wed Apr 07, 2004 3:24 pm
Location: Baltimore, MD
Contact:
Contact DJpowerHaus

SOHC->DOHC - Proof Read... suggestions.

Post by DJpowerHaus »

I've recently updated the SOHC to DOHC conversion page. I think I've covered everything but I might be wrong. I used CAPS to get all the part numbers and I think I got them all right.

http://projectzerog.com/sohc-dohc.shtml

Any suggestions or corrections?
Image
Getting the engine bolted in is about 10% of the way there.
The next 80% can go quickly with help and skill.
That last 10% takes about as long as the 90% that came before it.
Top
willmoodom
Knowlege Seeker
Posts: 39
Joined: Wed Feb 20, 2008 9:17 am

Post by willmoodom »

Image

I am seeing more holes on the head than the gasket has. Those little slits right around the cylinder of the head,there are 6 of them. what are they for? the slits are not on the block.
Top
willmoodom
Knowlege Seeker
Posts: 39
Joined: Wed Feb 20, 2008 9:17 am

Post by willmoodom »

just to answer my question, I guess they are nothing. Part of the casting
Top
slowquest
Addict
Posts: 112
Joined: Tue Jun 14, 2005 11:30 pm
Location: Cincinnati, Ohio

Post by slowquest »

The part numbers you have listed for both dohc engines that are the same part number....2.0 dohc's came in both 6 bolt and 7 bolt, 2.4 dohc's only came factory 7 bolt. which did you look up?
Top
Post Reply

Return to “Swap Mechanical”