Designed for Light Duty STICK ( SMAW or CC ) Welding.
1/16" and 3/32" E6013 Electrodes.
1/16" and 3/32" Stainless Steel Electrodes.
Scratch Start TIG Welding.
Output Range of 10 to 80 Amps.
Welds Material up to 1/8".
Plugs into Standard 115 VAC Receptacle.
Only Requires 20 Amps Circuit.
25mm Twist Lock Output Terminals .
Rugged output terminals allow easy polarity reversal and cable changes.
Heavy Duty 6 Gauge Welding Cables.
15 ft. Electrode Cable and Tweco Brand Electrode Holder.
10 ft. Work ( Ground ) Cable and Rugged Clamp.
Thermal Overload Protection.
Protective Case
TIG Kit:* 12.5' Air Cooled TIG Torch w/ valve, accessory kit, 10 ft. gas hose* regulator, and attached dinse connectors.
Like I said if your local I've got a 80CF tank of straight argon that basically full as I used the TIG about 3 minutes and didn't have the regulator opened up much. Also comes with a pack of filler rods. So if* your local this would be a ready to TIG weld setup.
500 picked up with tank or 430 shipped for just the welder.
