Driveshaft question

All the oily, spinning bits

Moderators: DJpowerHaus, mattmartindrift

Post Reply
Eric
Knowlege Seeker
Posts: 48
Joined: Sun Aug 20, 2006 10:57 am
Location: Wonder Lake, IL

Driveshaft question

Post by Eric »

I am planning to have the forward segment of the 2-piece driveshaft modified. Is it bad to have a slip yoke on each end of this one segment of driveshaft? I notice most of them have a slip yoke on one end and a plate with bolts on the other.
Top
DJpowerHaus
Sir Post A Lot
Posts: 1779
Joined: Wed Apr 07, 2004 3:24 pm
Location: Baltimore, MD
Contact:
Contact DJpowerHaus

Post by DJpowerHaus »

If it has a center support bearing I dont see why it would be a problem.
Image
Getting the engine bolted in is about 10% of the way there.
The next 80% can go quickly with help and skill.
That last 10% takes about as long as the 90% that came before it.
Top
Post Reply

Return to “Swap Mechanical”