4G64 in a Conquest???

blue_crush · Post by **blue_crush** » Sun Jun 11, 2006 9:46 pm

so if I am getting this right, i can put a 4G64 in a Conquest and run the conquest tranny?
Theirfor allowing me to keep my Unorthadox flywheel and 6 puck clutch?
Also plan on stroking the 64, if this will work.
Tell me if im wrong, I probably am.

Post by **DJpowerHaus** » Mon Jun 12, 2006 6:52 pm

You can do it and use your stock transmission, flywheel and clutch. I wouldnt stroke it though. If anything I'd put a 2.0 crank and some of these rods and pistons:

http://www.slowboyracing.com/more.php?id=5105&

Then you can say yes to 11,000rpm and still have 2.1L. $1063 sounds like a lot, but these are nice forged rods and pistons. It'd probably be cheaper than stroking the 2.4 though.

blue_crush · Post by **blue_crush** » Mon Jun 12, 2006 6:59 pm

cant you put the 2.0 head on as well?

Post by **DJpowerHaus** » Mon Jun 12, 2006 7:59 pm

Yeah... you'd sort of have to... with lots of head work too... to support that RPM.

blue_crush · Post by **blue_crush** » Sat Jun 17, 2006 2:05 pm

i agree, the only problem with the 11,000 rpms would be that the tranny cant shift past 6. i tried many times

Mike · Post by **Mike** » Sat Jun 17, 2006 3:28 pm

That's where the fc3s turbo II trans really comes into play.

blue_crush · Post by **blue_crush** » Sun Jun 25, 2006 9:49 pm

explain. never heard of this tranny. still sucks for me, because that means i still cant use my 6 puck and unorthadox flywheel.

Mike · Post by **Mike** » Sun Jun 25, 2006 11:48 pm

http://projectzerog.com/forum/viewtopic.php?t=138