2ga front cam sensor wire setup

tektic · Post by **tektic** » Fri Jan 27, 2017 2:21 pm

I'd like to run a 2ga cam trigger and sensor in conjunction with a crank sensor. I'm using a 2g head and a 7 bolt wide block but a 1g harness. Does anyone have a schematic for this?

Silverjoel · Post by **Silverjoel** » Sun Jan 29, 2017 2:15 am

This is kind of the opposite of what you want, but not really. It shows the wires in both the 1g CAS connector and the 2g CAS and crank sensor. Depending on what you are using for an ECU, you will need to invert the signal like in the pic. If you can flash the ECU to use the inverted signal you will not need to use this inverter. *Keep in mind that power would come from the 1g plug.

http://www.roadraceengineering.com/ecli ... g95-96.gif

devilsfutbol17 · Post by **devilsfutbol17** » Fri Feb 08, 2019 7:24 pm

Old post I know, but I wanted to add this bit of information because I did the swap and it worked for me. Details are in my post on tuners. https://www.dsmtuners.com/threads/2g-ca ... -153617495