Need clutch parts...

Eric · Post by **Eric** » Fri Sep 29, 2006 9:37 am

Hello,

To help keep my project moving I'm wondering if anyone has any stock clutch parts that they would let go for reasonable prices? I don't care if they are old and used so long as they will bolt up and I can make a document on fitting Bill's bell housing. So, if you have any parts just sitting around... let me know.

I still need a 6-bolt flywheel, pressure plate, fork and pivot ball.

Thanks,
Eric

Bill Hincher · Post by **Bill Hincher** » Fri Sep 29, 2006 1:12 pm

Here's what you need Eric

That is a Mitsubishi clutch fork, a short mits pivot ball and a Toyota throw out bearing and collar

Standard 9 in Toyota disc

The center of the flywheel must be opened to 31 mm

The hydraulic cylinder was designed for the left side of the bellhousing ( drivers side) the pilot bearing is standard Toyota

I will get a vin# from the demo Toyota Trans i used and get the proper year and make so its easier to get parts......all this stuff shouldnt be too hard to get at a local napa store

Bill

screemin eagle · Post by **screemin eagle** » Fri Sep 29, 2006 1:57 pm

is that a fwd flywheel or awd flywheel?

Eric · Post by **Eric** » Fri Sep 29, 2006 2:22 pm

Very nice. I've got the Toyota disc, slave cylinder and throwout bearing already.

Bill Hincher · Post by **Bill Hincher** » Fri Sep 29, 2006 4:08 pm

Thats a FWD flywheel

idreamidrive · Post by **idreamidrive** » Sun Oct 16, 2011 1:25 pm

I know this thread is old, but the pics are now down and would be great help if they are back up. That is unless these parts have changed for any reason.