tools are fun

Bill Hincher · Post by **Bill Hincher** » Sat Oct 08, 2011 8:52 pm

this is a pullmax P 9 and its what I been looking for, it cuts and shapes centers up to 1/4 in thick, the reason it was important to me was because now I can build any flexplate to any ring gear for any auto trans

they aint cheap, I had to go to Chicago and pic it up and then unload it
now I gotta rest a couple dayz >;o)

77amc · Post by **77amc** » Sun Oct 09, 2011 12:10 pm

You're gonna need a bigger shop before long Bill..

Does this give a broaching motion?

What part of Chicago? South East side?

Errol

Bill Hincher · Post by **Bill Hincher** » Sun Oct 09, 2011 12:15 pm

it was in Obama's basement

77amc · Post by **77amc** » Mon Oct 10, 2011 9:32 am

There might be some useful info for those of us that don't know these machines here..

http://www.practicalmachinist.com/vb/ge ... fo-198932/

E

Bill Hincher · Post by **Bill Hincher** » Mon Oct 10, 2011 10:27 am

I will never be able to use it in all its capablitity Errol, it has too many uses and the tools cost sooooooooooooooo much, I will stay with just what I need

Bill Hincher · Post by **Bill Hincher** » Thu Jan 12, 2012 8:32 am

Robert Venable · Post by **Robert Venable** » Fri Jan 27, 2012 2:52 am

How much we talking for a used one???

Bill Hincher · Post by **Bill Hincher** » Fri Jan 27, 2012 2:54 am

they usually run $7500 without any tools