4g64 7 bolt with km132

crshbndct · Post by **crshbndct** » Tue Mar 02, 2010 6:34 am

hi there. me and my girl along with our 2 year old daughter have a grand plan to fit a 4g64 to a starion. it is an 8 valve sohc with the intention to keep a stock looking engine bay. question is: will a wideblock 7 bolt flywheel fit a 4g63 starion clutch and will this mate up to a km132? thanks for any and all help in advance. please excuse terrible grammar i am posting this from a cell phone

Bill Hincher · Post by **Bill Hincher** » Tue Mar 02, 2010 8:46 am

your posting from your cell?

crshbndct · Post by **crshbndct** » Tue Mar 02, 2010 4:53 pm

yes. so does it fit?

Bill Hincher · Post by **Bill Hincher** » Tue Mar 02, 2010 9:36 pm

mechanic humor,' posting from your cell ' was too much to pass up

the 4G64 wide block should bolt right up to the bellhousing but the crank has to be a 6 bolt to accept the 54B flywheel, then you could reuse the Starion clutch, the only difference is in the throw out bearing, you have to choose between an intercooled or a non intercooled 54B engine to get the right clearance at the pressure plate

crshbndct · Post by **crshbndct** » Wed Mar 03, 2010 1:14 am

i think you dont understand. this is what i want to use:

4g64 (wideblock 7 bolt)
km132 (from a 4G63 starion)
4g64 flywheel
starion clutch (from afore mentioned 4g63 powered starion)

the car is a factory original 4g63 powered starion. maybe better known as g63b powered. there is not so much as a 4g54 headbolt within 300 yards of it, nor has there ever been.

again just to recap:

i want to use my 7 bolt 4g64 with the flywheel that came with it (not a 54b flywheel, not a 63 flywheel) and use a starion clutch on it and bolt a 4g63 starion km132 on the back.

as far as i can see, the only issue is that the input shaft may be too long or something

Bill Hincher · Post by **Bill Hincher** » Wed Mar 03, 2010 7:08 am

you will probabaly have to use the 4G64 clutch because it is quite a bit different then the 54b ( starion) clutch

crshbndct · Post by **crshbndct** » Wed Mar 03, 2010 3:00 pm

umm. your having me on right?

the car currently has a 4g63 in it. i want to know if the 4g63 clutch will bolt to the4g64 flywheel, and if said clutch flywheel will work with starion 4g63 gearbox.

thank you

crshbndct · Post by **crshbndct** » Thu Mar 04, 2010 1:48 am

This was just a quick dummy fit to see if it would all work when I put the 4G64 into my gsr111..

4G64 with 64 7 bolt fly attached

Starion clutch bolted to 4G64 flywheel

Starion gearbox all in place

Input shaft after gearbox unbolted again , it was coated in grease as a marker.