F/S Quest floorpan Near Memphis

77amc · Post by **77amc** » Sat May 23, 2009 10:14 am

Good morning. I thought that I was going to use this but it's to 'sharp' to just have laying around the backyard. (kids runnin around)
It was a 89 that had some rust only on the outer edges, under the side skirts about an inch in.

If i could get someone to post a pic I'd appreciate it. I'm not set up with a third party photo thingy..

I'm in Olive Branch, MS if you want to 'mapquest' it.

Or pm me and I'll shoot ya some pics.

100.00 for all or 25/ quarter.. OR trade too..

Errol

77amc · Post by **77amc** » Mon Jun 15, 2009 6:07 pm

I can even cut just the trans tunnel if someone needed to enlarge thiers..

E

77amc · Post by **77amc** » Wed Aug 05, 2009 7:35 pm

It's going bye bye this weekend..

Great for patchwork

E