Project Zero G Forums

I've been to 5 different shop and all of them don't want to touch my intake manifold.I know aluminum is tricky to weld. I just need the throttle body swapped. So my question is, what welder(MIG/TIG), wire and setting are you guys using to welder the intake manifold.

Bill could you explain the cooling system you posted some more? I I just picked up a toyota external thermostat and I been trying to figure out how I'm going to install it. I'm looking at your design too.

I'm located in North Carolina and lsr mike is right the engine is SOHC. I've just never seen one before. I wanted to know if the engine was a narrow or wide block, cause I was thinking about putting it in my 86 Ram 50. if the transmission is the same I might get that too. The montero is still in ...

I'm in the state east of you lol, and the mitsubishi's at the pull a part are mostly complete minus the Eclipses. Do you know if the blocks in the 3rd gen eclipse and 8th gen Galant are short or long block?

I saw a 1999 Montero Sport with a 4G64 and 5 speed transmission at the pull a part. Anyone else seen one or have any info on it.

No turbo I'm staying N/A because its going to be my DD. I got lucky and found a Hyundai Elantra with a 4G67 in it at the local pull a part. Wish I would have found it before I ordered a 4G63 wiring harness off Ebay, but I did get the wiring harness and ECU.

I'll start a build thread soon.

Hello everyone, I got an 1983 Dodge Ram 50 Sport about an month ago. I plan on swapping a 4G61, 4G67 or 4G63 N/A version but cant find a 4G63 swapped 1st gens. I know there was one guy on mightyd50.com but that site is down.

I know I need 2.0 mounts and narrow block transmission, but I wanna know ...