Page 1 of 1
Posted: Sun Sep 17, 2006 10:10 pm
by Fabritory
Did you go with the .20 over set of slugs?
Posted: Tue Oct 03, 2006 12:15 pm
by peregrine
pull that head and paint that block!!!!!!!!!!
Posted: Tue Oct 03, 2006 12:29 pm
by DJpowerHaus
Or at least tape it off and paint it! Use some engine enamel... get some rubber gloves or something and rub the wet paint into the casting. This REALLY helps paint stick to cast iron. RUB IT IN!
Put a light on it to heat it up (especially if its black) and it'll self level out and will look amazing. My block (pictured above.. at the very top) looked worse than yours at one point.
Posted: Tue Oct 03, 2006 1:59 pm
by DJpowerHaus
Yeah.. $50 would be a bit extreme. You could powder coat it for that much.
Posted: Sun Oct 08, 2006 2:39 pm
by Fabritory
The old shcool hot rod head at the machine shop i took my engine to thought it would be funny to just paint it chevy orange