Project Zero G Forums

Posted: **Sat Jul 30, 2011 5:09 am**

G'day from Aussie Land! Thought I'd show you all my Galant that i'm fitting a 4g63 into....lots of pics to wet appetite..and some more info here..
http://www.sigma-galant.com/viewtopic.php?f=48&t=6477

Big thanks to this site and its members...Lots of great info on here!

Posted: **Mon Aug 01, 2011 7:26 am**

I like the innovative design of using the rear water outlet.It allows for easy plumbing of heater core lines and keeps the factory temp sensors. Where is your thermostat located?

Posted: **Wed Aug 03, 2011 10:06 am**

92 GSR-4 wrote:I like the innovative design of using the rear water outlet.It allows for easy plumbing of heater core lines and keeps the factory temp sensors. Where is your thermostat located?

near radiator inlet at front...housing to go underneath is yet to be made...

Posted: **Sun Aug 07, 2011 1:49 pm**

Looks great. Lots of good ideas going on.

Posted: **Wed Aug 10, 2011 9:38 am**

crank sensor mount.. bolts on at alt mount and a bolt on oil filter housing

Posted: **Wed Aug 10, 2011 11:09 pm**

Love it!!!! Keep up the good work man.

Posted: **Sat Aug 13, 2011 9:56 am**

Where's the wheel you are using that crank sensor mount with ??? I am needing to do the same.

Posted: **Sat Aug 13, 2011 10:07 am**

JDOliver wrote:Where's the wheel you are using that crank sensor mount with ??? I am needing to do the same.

crank sensor mounted, just need an alloy pulley and three teeth put in it...and its done!

Posted: **Sun Aug 14, 2011 10:30 am**

Thanks. I just noticed the Mookeeh pulleys for the 54b have a steel toothed wheel on the aluminum pulley. I missed that before but since the pickups are magnetic it makes sense.

Posted: **Sun Aug 21, 2011 5:36 am**

Posted: **Sun Aug 21, 2011 11:32 am**

Very cool build! Where did you get the plate that flips the exuast manifold. That looks like a great alternative to a top mount manifold without the cost.