i need o2 housing set up for rwd swap

IDriftNaked · Post by **IDriftNaked** » Thu Jul 31, 2008 12:23 am

i was just wondering where or who i can turn to, to have this o2 housing made for me. or does anyone have one made already that you wanna sell??
thanks in advance
David

IDriftNaked · Post by **IDriftNaked** » Thu Jul 31, 2008 12:27 am

im using a dsm 16g by the way

Post by **DJpowerHaus** » Thu Jul 31, 2008 4:51 am

Buy a flange and a mandrel bend to fit into that flange and fit it up and mark it. Also, you'll need to figure out how you're doing your wastegate. If you get it marked up, just about anybody with a welder could weld it all together.

Once I get Craig and Will's cars swapped this fall, I should have a jig made so I can make a batch of downpipes that will work with the stock engine placement, stock (or stock replacement) exhaust manifold with stock (or stock replacement) turbo and stock (or stock replacement) exhaust.

89coltgt · Post by **89coltgt** » Mon Sep 08, 2008 4:45 pm

I think he means internal wategate.